AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
4 pin molex to 3x3pin fan connectors4/20/2024 ![]() ![]() While the "flap" is pressed down, you pull out the wire.Press down the small "flap" on the top of the crimp terminal, which you access through the slots on the wide side of the connector, as shown on the second photo.You will only need a small screwdriver, scissor, knife or similar small device with a thin tip. ![]() It is very easy to remove wires from FAN connectors: ![]() You can use these 3-pin FAN connectors with existing crimp terminals already found on your wire, or you combine them with our original FAN crimp terminals. BUYMINERS.CA Chassis Fan Hub CPU Cooling 10 Port 12 V Molex to PWM Connector with 3 & 4 Pin - Efficient PC-Fan Controller System with Adhesive Tape Dedicated Supply from PSU to Link Multiple Points 4. If you want to own the highest quality in the world of connectors, this is it. The special short-version guidance "wings" on these FAN connectors will not get in conflict with any heatshrink which is applied over the connector. They always fit perfectly and go smoothly into the mating connectors. I could connect the 3 pin cables straight to my motherboard without a problem using PWM. 2 of these were 3-pin standard fan connectors and the other three were 4 pin Molex connecors without a tachometer cable (2 wires were connected to the Molex). Compared to all the no-name ones from China, this is just a different league. I have an AZZO Solano 1000 case for my new computer which included 5 fans. This is manufacturing precision at its best, which you also recognize in every aspect when you work with these 3-pin FAN connectors. MOLEX typically only manufactures a darker blue shade and call it black, but our custom productions are always as black as technically possible. Sort by date Sort by votes Dark Lord of Tech Retired Moderator. These are the original 3-pin FAN connectors manufactured in the USA by the MOLEX company. Should I plug in both the molex and the 3 pin fan connector or just the 3 pin Solution Dark Lord of Tech Just the 3 pin is fine, use molex if you dont have any headers left on the board. ![]()
0 Comments
Read More
Leave a Reply. |